Secabo C40 Instructions d'exploitation télécharger pdf (Page 21)

• As soon as you clicked “OK“ in the following window, the cutting plotter will

begin to plot the contour (with a distinct offset). During the calibrating it is

recommended to use a plot pen and to change to the cutting head at a later

time.

• Now remove the plot and measure the offset in both directions as shown in

the following picture.

• Now you just have to enter the calculated offset in the corresponding menu in

the FlexiStarter, so that the contours are always cut correctly. For this please

click the “Options“ in the menu “Contour cutting“ and afterwards on “Edit“.

• Please enter “Offset X“ and “Offset Y“ into the fields. Please note that “Offset

X“ has to be negative which means it has to be entered with a prefixed “-“.

All values are to be entered in “mm“ and “.“ as separation marks.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Secabo C40 Instructions d'exploitation Page 21